Siemens SIREMOBIL Iso-C 3D Installation Instructions Manual page 59

3. Part of activities independent of serial number
Installation of the support arm on the monitor trolley
Mark for the keyboard tray
Fig. 24 Installation of the support arm
•
Open the rear cover of the support arm base on the TFT display.
•
Route the free cable ends of the new power line cables (included in the attachment of the
TFT Display) downwards through the support arm holder (2/Fig. 24), through the center
cable bush of the monitor trolley and through the lateral rail to the ON/OFF assembly
(Fig. 23) and connect them to the terminal blocks:
NOTE
- Connect the brown cable ends to terminal block X2.1
- Connect the blue cable ends to terminla block X2.2
- Connect the protective ground cable ends (ye/gn) to the protective conductor bars
(1/Fig.23).
•
Route the cable ends of the video cables upwards through the support arm base
(1/Fig.24) and further through the support arm holder (2/Fig. 24).
•
Place the support arm base above the center cable bush (Fig.24).
•
Starting with the logbook compartment, tighten the screws of the support arm base on
the monitor trolley. Use 4 Allen screws M6 x 20, 4 lock washers and 4 plate washers for
this (Fig. 24).
Siemens AG
Medical Solutions
The new poer line cables have a length of approx. 2.6m and are
equiped with a straight femal connector on one cable end.
SPR2-230.814.01
Rev. 05
Page 9 of 42
08.04 CS PS 24
6 - 9
SIREMOBIL Iso-C 3D