Safety Notes; Scope - WAGO 750-563 Manual

1.4 Safety Notes

Warning
Switch-off the system prior to working on bus modules!
In the event of deformed contacts, the module in question is to be replaced, as
its functionality can no longer be ensured on a long-term basis.
The components are not resistant against materials having seeping and
insulating properties. Members of this group include: aerosols, silicones,
triglycerides (found in some hand creams).
If it cannot determined that these materials appear in the component
environment, then additional measures must be taken:
- install of the components in an appropriate enclosure
- handle components only with clean tools and materials.
Attention
Soiled contacts may only be cleaned with ethyl alcohol and leather cloths.
This helps ensure compliance with ESD information.
Do not use any contact spray. The spray may impair the functioning of the
contact area.
The WAGO-I/O-SYSTEM 750 and its components are an open system. As
such, the system and its components must be installed in appropriate
housings, cabinets, enclosures or in electrical operation rooms. Access must
only be provided via key or tool to authorized, qualified personnel.
The relevant valid and applicable standards and guidelines concerning the
installation of switch boxes are to be observed.
ESD (Electrostatic Discharge)
The modules are equipped with electronic components that may be destroyed
by electrostatic discharge. When handling the modules, ensure that the
environment (persons, workplace and packing) is well grounded. Avoid
touching conductive components; e.g., gold contacts.

1.5 Scope

This manual describes the Analog Output Module 750-563
2 AO 0/4-20mA / 6-18V DC 16 Bit of the modular WAGO-I/O-
SYSTEM 750.
Handling, assembly and start-up are described in the manual of the Fieldbus
Coupler. Therefore this documentation is valid only in the connection with the
appropriate manual.
WAGO-I/O-SYSTEM 750
I/O Modules
Important Comments
Safety Notes
• 7