WAGO 750-563 Manual page 22

22 • 750-563 [2 AO 0/4-20mA / 6-18V DC 16 Bit]
Parameter Setting
Register
Bit 9: Substitute value after I/O module timeout
0: *
1:
Bits 10, 11: Behavior after I/O module timeout
Bit 12: Reserved
Bit 13 .. 15: Switch-on delay
* Factory setting
Function
Manufacturer substitution value
User substitute value
The reaction depends on register 32, bit 2.
Bit 11 Bit 10 Behavior
0 0 * Output 0 V or 0 mA. This is achieved by switching off the
scaling and calibration mechanisms and outputting values
according to the operating mode, which produces approximately
0 V with an imprecision in the lower two-digit millivolt or
microampere range.
0 1 Retain last value
1 0 Substitute value, as configured in register 32, bit 9
1 1 Put output in tri-state
The switch-on delay is the time that should pass after an ongoing overtemperature
error of the output driver until the error state is left. This way, for example, pulsing
can be avoided, which otherwise could be misinterpreted by the actuator as a strong
value change.
The values of the time fluctuate by ±10ms.
Bit 15 Bit 14 Bit 13
0 0 0
0 0 1
0 1 0
0 1 1
1 0 0
1 0 1
1 1 0
1 1 1
Memory
Switch-on delay
0 ms
100 ms
200 ms
300 ms
* 500 ms
750 ms
1 s
2 s
Access Factory setting
WAGO-I/O-SYSTEM 750
I/O Modules