Easy Display Mode; Activating Easy Display; Deactivating Easy Display; Other Settings - Sunrise Medical Quickie Attitude Directions For Use Manual

Easy Display mode:

Fig.3.14
By activating Easy Display, the following graphical symbols
presented in section 3.2.2 are enlarged on the display.
•• indication of the current speed travelled
•• indication of the daily kilometres travelled (requires prior reset,
see section 3.2.10)
•• indication of the remaining battery capacity including
indication of the expected remaining range
The relevant display can be selected by tapping button [2] on
the controller.
If buttons [1] or [3] are tapped, the display shows the assistance
level for about 3 seconds that can be increased or decreased
using the two buttons.

Activating Easy Display:

From the start menu you go via Menu – Settings – Easy Display
to display "on/off".
If Easy Display is activated, the sMMI automatically goes into
this mode every time it is switched on.

Deactivating Easy Display:

To deactivate the mode you need to press button [2] on the
controller for about 2 seconds. Via Menu – Settings – Easy
Display you arrive at the display "on/off".
NOTE: When Easy Display is activated the functions "pushing
aid" and "recuperation" are not available.

Other settings:

As standard, your sMMI has a German user interface. However,
if required, an English / Dutch / French interface can be
activated. The software status of the sMMI, the motor and the
battery pack can also be retrieved from the menu item
"information". Language activation or status requests are
performed similarly to the procedures described in the previous
sections via various menus and sub menus.

USB port: (Fig.3.14)

The sMMI has a USB port [14], which is primarily used by your
specialist dealer to carry out maintenance and
diagnosis work. Ensure that the rubber cover is always fully
inserted and seals the port. If the sMMI is not
fully sealed, moisture can get inside or fog the display from the
inside.
In addition to English we can also set Dutch and French.
However, if required, an English / Dutch / French interface can
be activated.
36 Attitude/Attitude Hybrid Rev.3.0