Starting Up; Information On The Operating Modes; Inserting The Battery; Connecting The Battery To The Motor Cable - Sunrise Medical Quickie Attitude Directions For Use Manual

7.0 Operation

Starting up:

Information on the operating modes:

Essentially, the battery has two operating modes. It is either in
"Active mode" or in "Deep Sleep mode".
In Active mode the battery consumes at least 5 mA per hour
(consumption of the battery's own electronics).
To keep the battery's own consumption as low as possible, the
battery automatically switches to the so-called Deep Sleep
mode after 48 hours.

Inserting the battery:

• Place the battery [1] on the battery slide rail [6] mounted on
the add-on bike.
• Push the battery [1], as shown in the diagram, up to the front
edge of the battery slide rail [6].
• Lock the battery [1] by carefully turning the key [2] clockwise
until it stops. The battery can no longer be removed from the
battery slide rail.
• Remove the key [2] from the battery [1].

Connecting the battery to the motor cable:

• Insert the plug [7] of the cable coming from the motor into the
socket [3] on the battery [1].
• The two parts are correctly aligned and interlocked
automatically by means of a magnetic latch.
Before inserting the plug [7] in the socket [3], ensure
that both parts are clean and there are no metallic
particles on them. If you detect such particles, use a dry,
clean cloth to remove them.

Switching on the battery:

If the battery has been used within 48 hours it does not need to
be switched on. The Add-on bike is ready for use and can be
switched on via the sMMI and used.
If the battery is first being activated now, or if it has not been
used for more than 48 hours (Deep Sleep mode), it needs to be
switched on.
• Tap button [4].
• All the LEDs [5] flash three times to show it is switched on.
• Your add-on bike is now ready for use and can be switched
on via the sMMI and used.
CAUTION!
If the motor cable is not yet connected to the battery, the battery
will still be in Active mode when switched on.
If the battery cannot be switched on, the cell voltage may be too
low. In this case connect the charger and then press the on/off
button [4]. The battery will be charged for a minute.
Attitude/Attitude Hybrid Rev.3.0
Fig.7.1
1
Fig.7.2
7
Fig.7.3
6
2
3
4
5
47