Attaching The Drive Wheel - Sunrise Medical Quickie Attitude Directions For Use Manual

Attaching the drive wheel:

Make sure that all the components attached to the wheel have been
installed in accordance with the instructions and specifications of the
respective manufacturer. This relates in particular to the brakes and
the gear box. Do not forget to reinstall the torque support [20] in the
same position as it was taken from.
Then push the wheel into the slot of the frame and tighten it using the
hub axle nuts [18] in the following sequence:
•• first tighten on the side of the gear box (diagram A)
•• then on the side of the brakes (diagram B)
In each case, the tightening torque of the two nuts is between 30 and
40 Nm.
Ensure that the tooth lock washer [19] is located beneath the axle hub
nut otherwise there is the risk of the axle hub nut [18] coming loose.
If your wheels are equipped with a quick-release mechanism, please
observe the manufacturer's specifications on installation and the
tightening torque.
If the wheel is correctly attached to the frame, the motor with the end
of the cable that leads to the battery can be connected. In doing so,
make sure the plug [15] is correctly aligned with the socket [17]. The
curved surfaces ([A] and [B]) must be aligned with each other.
Then fasten all cables and leads with cable ties to the bicycle frame
and perform a final function test.
WARNING!
• Make sure the cables are laid correctly. Failure to do so could lead
to the cable getting caught in the brake disc, the drive or the
spokes and by locking the wheel cause a fall.
• Never install the motor without the torque support [20]. This could
cause a total loss (twisting off the cable). This voids all warranty or
guarantee claims.
CAUTION!
• It is essential to observe the instructions and specifications of the
manufacturer of the various components attached to the wheel in
all your installation work. This particularly applies to the brakes, the
gear box and quick-release mechanism.
• Carry 5 cable ties with you along with your repair tool, to securely
fasten any loose cables during a trip.
• Installing or removing the drive wheel is best carried out when the
add-on bike is upside down (standing on its crank and connecting
frame). Remove the sMMI attached to the handlebars first so that it
does not get damaged.
• Always use the original gear cluster built by the bicycle
manufacturer. Using other makes may lead to restricted function or
to the gear cluster scraping the chainstays
40
Fig.3.18
Attitude/Attitude Hybrid Rev.3.0