Programming Options By The Specialist Dealer; Firmware Updates And Relaying Them To The Motor And Battery - Sunrise Medical Quickie Attitude Directions For Use Manual

Programming options by the specialist dealer:

Your specialist dealer can tailor the travel characteristics of your add-on bike to your requirements using a diagnosis and programming
software. Generally, the factory settings are ideally tailored to the respective model and do not need to be changed. The factory
settings may vary depending on your bicycle model (mountain bike / trekking).
Nevertheless, if adjustments need to be made, the following parameters can be programmed:
Speed of the pushing aid forwards:
Standard assistance level:
sMMI standard settings:
sMMI lock:
Service interval:
Wheel circumference:
WARNING!
• This parameter may only be changed if the statutory requirements are complied with (max.25 km/h for add-on bikes) and in the
event of misuse this leads to the warranty and product liability being void.
• Similarly, unlawful tampering can have criminal consequences if investigated by the police.
• All changes to the travel parameters are recorded in the sMMI data storage device.

Firmware updates and relaying them to the motor and battery:

As part of product maintenance and to expand the range of functions, firmware updates are available to download to specialist
dealers from time to time. Your specialist dealer will be happy to advise you.
If you have loaded an update to your sMMI from your specialist dealer, the new firmware will install when you next start up your add-
on-bike.
To do this, proceed as follows:
•• Place the sMMI on its dock [5] as described in section 3.1.
•• The connection to the motor and battery is automatically established and instead of the start menu, a warning
note appears "firmware update is running". A bar chart also shows the progress of the data transfer.
•• Once the data is fully transferred, the screen display automatically changes to the start menu (see section
3.2.2).
•• Check the settings stored by you in the sMMI if applicable. This may have changed as a result of the update.
CAUTION!
Do not interrupt the update process, for example, by removing the sMMI from its dock This may lead to damage.
Attitude/Attitude Hybrid Rev.3.0
Set to 4 km/h as default.
The assistance level that is always available when the Pedelec is switched on.
Can be set in the range 0–5, the value 3 is pre-programmed as default.
Language settings, time format (12/24 h)
Optionally, the sMMI can be permanently connected to the motor. This results in the
sMMI only being operational with this one motor/system and cannot be used with
another motor.
Depending on the specified suitable maintenance interval, this can be set or reset by
date or kilometres travelled (depending on which comes first).
To correctly display the speed and to comply with statutory requirements with regard to
speed limitation, the bicycle dealer can change the wheel circumference. This is only
necessary if the drive wheel is subsequently fitted with a tyre which increases or reduces
the original wheel circumference, or the motor has been reassigned to a larger or
smaller rim.
37