Fitting And Removing The Smmi; Functions Of The Smmi - Sunrise Medical Quickie Attitude Directions For Use Manual

Fitting and removing the sMMI

Fitting:
• Place the sMMI [4] in the correct position, (the neodrives
logo faces the rider) and skewed at an angle of about 30
degrees to the dock [5] (Fig.3.1).
• Turn the sMMI [4] on the dock [5] using slight pressure by
30 degrees clockwise so that both components are in
alignment, (Fig.3.2).
• The electrical connections to the controller, motor and
battery pack are thereby automatically established.
Removing:
• Turn the sMMI [4] on its dock [5] by about 30 degrees
anticlockwise.
• The electrical connections are thereby disengaged and the
sMMI [4] can be removed.
• Before removing, the sMMI needs to be switched off, (see
"Functions").
CAUTION!
• To protect your add-on bike from unwanted use by a third
party or against theft, the sMMI should always be removed
from the handlebar when not in use.
• Removing the sMMI, though, does not replace securing your
add-on bike against theft by other suitable means (using a
bicycle lock, a safety chain or similar device).

Functions of the sMMI

Switching On:
To switch on the sMMI, tap the menu button [3] on the
controller. After a few seconds a welcome screen appears,
followed by the start menu, which is shown to the side.
If functions are already activated or the battery is not fully
charged, the display of your sMMI may differ from the
illustration in some parts.
Switching off:
To switch off your add-on bike you need to press down button
[2] on the controller for about 2 seconds when the start menu is
displayed. This takes you to the sub menu depicted to the side,
in which display you can jump up or down using buttons [1] and
[3] of the controller.
The selected field in each case is displayed within a U-shaped
border.
Select the field "Turn off" and tap button [2]. Your add-on bike
is now switched off.
Automatic switch-off:
If your add-on bike is not used for 10 minutes, the system is
automatically switched off.
Pressing the menu button again switches the system on once
more.
CAUTION!
Do not switch your Pedelec off by removing the sMMI, the
electronics could be damaged by this.
Attitude/Attitude Hybrid Rev.3.0
Fig.3.2
Fig.3.3
Fig.3.4
Fig.3.5
6
115
km
8
9
10
1
2
3
7
0
km/h
11
12
29