Trouble Shooting; Emergency Seat Movement Mode - Sunrise Medical QUICKIE Sedeo Pro Advanced Seating Manual

9.0 Trouble shooting

If the wheelchair is not working, as it should, check the
following points.
• Check whether the batteries are charged.
• Turn the wheelchair off and then back on again.
• Check whether the battery plugs are all securely in place.
• Check whether the freewheel lever is in the DRIVE position
• Check the position of the speed regulator.
• Make sure that the controller isn't locked Controller
If the problem has not been resolved:
• Consult the trouble shooting section for the controller
Controller

9.1 Emergency Seat Movement Mode

• Read the following instructions before starting!
• When the R-Net electronic detects an actuator feedback
fault, the seating module will stop all actuator movements
that may cause risks for a mechanical clash.
• If you attempt to operate actuators this will cause a system
"beep" signal as soon as the joystick is moved forwards or
backwards within the seating mode. No actuators
will operate.
• There are situations where a user still needs to be moved
into a more comfortable or safe position due to ease the
transfer out of the seat.
• If seat movement is required, the Wheelchair control can
be switched into the emergency seat mode to operate
all actuators. IN THIS MODE THE CONTROL IGNORES the
actuator feedback and clash rules SO THERE IS A RISK
OF DAMAGE.
WARNING!
Due to the disabled clash rules within this mode function, it is
important to move the seat functions careful and in a specific
order to prevent unsafe conditions or damages to the seat.
32
Accessing the Emergency Seat Movement Mode
1. There is a specific "Emergency Seat Mode" activation
switch attached to the inner plastic cover of the right side
flip back armrest (Fig.9.1). The switch may be covered with
a label. Remove the label to be able to activate
the switch.
2. With the chair switched on and the controller in seating
mode, press and hold the "Emergency Seat Mode"
activation switch and deflect the joystick forward for 30
seconds to activate the emergency seating mode.
3. Once in the emergency seating mode you will hear a beep
sound every second.
4. When in the emergency seating mode, all seat elements in
the joystick display will flash.
5. If the chair has a CTRL+5 the colour LEDs will turn
solid blue.
6. The chair will be in drive lockout, showing the red turtle in
the display.
7. If in Memory or the Seat Lift function is selected in the
display, the actuators will not move when deflecting the
joystick forwards or backwards.
8. Selecting a single actuator axis (Backrest Recline, Seat Tilt
Back, Seat Tilt Forward, Foot Lift, Foot Length) with a left/
right joystick deflection, you can then move these single
actuators at 50% speed in both directions.
Fig. 9.1
Sedeo Pro Advanced/Advanced UP Rev.A