Docking And Dedocking; Docking: Fig.6.1 - Fig.6.5 - Sunrise Medical Quickie Attitude Directions For Use Manual

6.0 Docking and Dedocking

WARNING!
• Always make sure that the device is switched off before
docking and dedocking.
• Ensure the wheelchair is fully connected with the add-on
bike before use, by using the handgrip A.
• As with all moving parts, there is a risk that fingers and / or
clothing could become trapped. Please always handle
carefully.
Refere to the docking check list below:
Docking Pins
Fully locked In
Docking Levers
Fully Locked In
CAUTION!
• Always keep the docking system clean.
• Clean it after every trip paying particular attention to sand
and mud.

Docking: Fig.6.1 - Fig.6.5

• Drive your wheelchair as close as possible to the add-on
bike.
• The 2 docking pins on your wheelchair should stay directly in
front of the lower docking connector.
• The add-on bike should stand on an even surface.
• Lock the brakes of your wheelchair.
• Pull it towards you by using the handgrip, until the 2 docking
pins lock into A.
• Now push the add-on bike upwards/forwards until the stand
wheels and the castors leave the ground B.
• Swing the upper docking connector downwards until it stops,
C.
• Lower the add-on bike until the upper docking connector is in
contact with the front frame of your wheelchair.
• Pull the red locking lever backwards until it locks firmly and
completely, D.
• Ensure the wheelchair is fully connected with the add-on
bike.
Attitude/Attitude Hybrid Rev.3.0
Fig.6.1
Fig.6.2
√
√
Fig.6.3
Fig.6.4
Fig.6.5
A
B
C
D
13