Ceiling Hardware; Adaptor Plate Installation - Casablanca Mission Owner's Manual

M
ISSION
CROSSBAR
MOUNTING
BRACKET
Note: After removing the old fixture, check the outlet box
to insure that it is supported by a joist or beam across its
upper surface. If not, a 2" x 4" stud must be installed.
Step 1. Remove the knockout plug in the center of the outlet
1
box or drill a " hole for the lag screw to pass through. Then
/
2
1
drill a " guide hole into the joist or beam to a depth of 3".
/
4
CAUTION: To reduce the risk of personal injury,
use only the mounting hardware provided with
the approved outlet box to install the crossbar
mounting bracket.
WARNING!
SUPPORT DIRECTLY TO
BUILDING STRUCTURE ONLY.
4
™

CEILING HARDWARE

WIRE NUT (4)
SUPPORT INSTALLATION PARTS
CANOPY
ADAPTOR
PLATE

ADAPTOR PLATE INSTALLATION

ADDITIONAL HARDWARE
2 1
/
4
HEAD SCREW (2)
1" x 8-32 ROUNDED
HEAD SCREW (2)
LARGE
FLAT WASHER
/ " (1)
3
8
LAG SCREW
/ " #7 X 5" (1)
3
8
JOIST
CEILING FAN
APPROVED
WIRING BOX
CROSSBAR
MOUNTING
BRACKET
FLAT
WASHER
APPROVED
OUTLET BOX
HARDWARE
" x 8-32 ROUNDED
FLAT WASHER (2)
CEILING
WIRING
RIDGE
SIDE
DOWN
GREEN
GROUND
WIRE