Download Print this page

Advertisement

Quick Links

INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
mOUNTINg RECOmmENDATIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
FAN INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
OPTIONAL EXCLUSIVE LIgHT FIXTURE INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
CONTROL FEATURES:
Versa•Touch 2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
TROUBLESHOOTINg
Safety and the proper operation of your Casablanca fan both require a thorough knowledge of the
product and proper installation; therefore, before attempting to install and operate your Casablanca
fan, read this owner's manual completely and carefully. Retain this manual for future reference.
cauTion: To avoid possible electrical shock, make certain that electricity is turned off at
the circuit breaker or fuse box before attempting any installation procedure.
• CAUTION: RISK OF ELECTRICAL SHOCK! All wiring must be performed in accordance with national and local electrical
codes. If you are unfamiliar with the wiring codes, you should use a qualified electrician. To avoid overheating and
possible damage to other equipment, do not install control to a receptacle, fluorescent light fixture, motor operated
appliance, or transformer-supplied appliance.
• This fan is designed to be installed on an existing electrical outlet box. The outlet box must be UL Listed for ceiling fan
installations, if it is not, a new box must be installed. Casablanca extension poles are available for sloped or high ceiling
installations.
• This ceiling fan requires a grounded electrical supply of 120 VAC, 60 Hz and a minimum 15 amp circuit. The maximum
current requirement for the fan with light fixture is 3.8 amps. The fan uses about 1 amp or 100 watts. Maximum light
current is 2.8 amps or 340 watts of lighting.
• Where wire nuts are employed, be sure all bare wires are within the connectors. When installing the canopy hatch, make
sure all wires are within the canopy and that no wires are being pinched.
use only genuine Casablanca blades, light fixtures, and accessories.
• The blades in each pack are matched for
equal weight to assure smooth fan operation.
If more than one fan is being installed, be
careful not to mix blades from different
cartons.
• Inspect the contents of your carton for
possible shipping or handling damage and
report any such damage directly to your
authorized Casablanca dealer.
• It is always a good idea to have an assistant
to help with the installation.
• When cleaning, painting, or working near
your fan, be very careful of the fan and
blades. Always turn the power OFF to the
ceiling fan before servicing it, working on
it, or replacing light bulbs.
• Never insert anything into the path of the
fan blades while the fan is in operation.
• Never install a fan over a pool or spa.
• Never operate a fan that has been damaged in
any way. Contact Casablanca Fan Company by
calling 1-888-227-2178, or contact your local
authorized Casablanca dealer for assistance
in obtaining service.
CONTENTS
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16
READ AND SAVE THESE INSTRUCTIONS

SAFETY FIRST

BEFORE YOU START
For best performance and for your warranty to be valid,
(remove fuse for The
circuiT you will be
CIRCUIT BREAKER
(Trip breaker for The
circuiT you will be
PN 8943540
NOTES
FUSE BOX
working on)
working on)
AT0708
18"
70"
84"
1 1

Advertisement

loading

Summary of Contents for Casablanca Marrakesh

  • Page 1: Safety First

    • Never install a fan over a pool or spa. • Never operate a fan that has been damaged in any way. Contact Casablanca Fan Company by calling 1-888-227-2178, or contact your local authorized Casablanca dealer for assistance in obtaining service.
  • Page 2 mOUNTINg RECOmmENDATIONS Before mounting your Casablanca fan, read the following helpful recommendations. The location of the fan, air circulation, and fan size are all important factors to consider before installation. Location Ceiling fans have practical uses in almost every room in your home. We suggest you follow these mounting recommendations as you decide where to install your Casablanca fan.
  • Page 3 ™ arrakesh INSTALLATION INSTRUCTIONS Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check them against the parts listed in instructions. Before discarding packaging material, be certain that all parts have been removed. gETTINg STARTED Carton Contents Be sure to use only genuine Casablanca blades.
  • Page 4 CROSSBAR mOUNTINg BRACKET INSTALLATION JOIST note: After removing the old fixture, check the outlet box to insure that it is supported by a joist or beam across its upper surface. If not, a 2” x 4” stud must be installed. Step 1.
  • Page 5 ™ arrakesh CANOPY INSTALLATION Step 4. Attach the canopy to the crossbar mounting bracket with three of the 8-32 x 4 ” long canopy screws and lock washers provided with your Casablanca fan. Hand tighten until snug against the ceiling. note: On sloped ceilings, align the canopy opening toward the top or peak of the room.
  • Page 6 BLADE HOLDER, mEDALLION AND BLADE ASSEmBLY Step 6. Align the medallion over the bracket, with the set screw towards the edges of the blade and place the medallion over the wider end of the bracket. When it feels engaged, push on it until the other end snaps in place.
  • Page 7 ™ arrakesh BLADE ASSEmBLY ON FAN INSTALLATION BLADE ASSEmBLY BLADEHOLDER SCREW 12-24 X 5/8 (2 PER BLADE) Step 10. Take a blade assembly and insert the foot of the blade iron between the motor adapter and the motor. Tip: The screw showing on the motor should be between the 2 mounting holes for the blade iron.
  • Page 8 BLADE ASSEmBLY ON FAN INSTALLATION Step 12. Rotate blade assembly until the other blade iron hole aligns with the cut-out and again, install and tighten screw by hand only. Repeat steps 11 and 12 until all 3 blade assemblies are installed this way. Perma•lock™...
  • Page 9 ™ arrakesh FAN PREPARATION Step 17. Align the motor cover key hole slots with the three screws in the motor adapter. Once the cover clears the screw and washers, turn counter-clockwise to engage Step 18. Securely tighten the screws by hand until snug. KEY HOLE SLOT HANgINg THE FAN HOUSE WIRINg...
  • Page 10 WIRE DRESSINg Step 21. Tuck the wires into the canopy, wire nuts pointed upwards, the WHITE and gREEN wires on the opposite side from the BLACK wires. Keep all wires clear of the canopy opening. CANOPY HATCH INSTALLATION Step 22. Install canopy hatch with the last canopy screw and lock washer.
  • Page 11 ™ arrakesh INSTALLINg THE FINIAL Step 25. Install the finial onto threads and turn clockwise until snug.
  • Page 12 ® •T ersa ouch SAFETY FIRST Warning: To reduce the risk of electrical shock, this fan must be installed with an isolating wall control/switch. Versa•Touch2 ♦ INSTALLATION W-72 CONTROL HOLDER DRYWALL WOOD SCREW SCREW W-72 ANCHOR SCREW 6-32 X ” 6-32 X 1”...
  • Page 13 ® •T ersa ouch Versa•Touch2 oPeraTion SEND SIgNAL Fan Control LIgHT To start the fan. Press the selected speed button to run the fan at the desired speed. LO=Low speed mED=medium speed HI=High speed To turn off the fan. Press the FAN OFF button. Airflow Direction To reverse the airflow press the REVERSE button.
  • Page 14 TROUBLESHOOTINg TIPS Please refer to this troubleshooting guide before requesting service or contacting your dealer for assistance. PROBLEM POSSIBLE REMEDIES Fan will not start • Check the main circuit fuses, circuit breakers, and wall switch position. Check all wire connections. Make sure the power is turned off during this inspection. •...
  • Page 15 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected, Consult the dealer or an experienced radio/TV technician for help. Note: Any changes or modifications to the transmitter or receiver not expressly approved by Casablanca Fan Company may void one’s authority to operate this remote control. PRODUCT SPECIFICATIONS...