BLADE TO BLADE HOLDER INSTALLATION
BLADE SCREW
(4 PER BLADE)
RUBBER GROMMET
(4 PER BLADE)
Step 10. Insert a rubber grommet through
each blade hole of every blade. Inspect
both sides of the blade to assure that
the lips of the grommet are fully engaged.
CORRECT INSTALLATION
INCORRECT INSTALLATION
Step 11. Attach the blades to the blade
holders by first pressing the blade badge
into the blade, then installing the blade
holder using the four blade screws pro-
vided for each blade.
Using the screwdriver, tighten securely
by hand only.
NOTE: When assembling the blade
holder assure that the tapered
extrusions face the blade.
BLADE HOLDER
BLADE
BLADE & BLADE HOLDER HARDWARE
BLADE
BADGE
RUBBER GROMMET INSTALLATION
BLADE INSTALLATION
BLADE
BADGE
M
ISSION
BLADE
HOLDER
™
BLADE
HOLDER
BLADE
BLADE
BADGE
7