Hanging The Fan; Canopy Electrical Connections; Canopy Hatch Installation - Casablanca Mission Owner's Manual

M
ISSION
Step 5. To hang the fan body in the canopy, hold the fan
body firmly and insert the nylon ball into the canopy open-
ing. Rotate fan body until slot on nylon ball fits into pin
opposite canopy opening.
NOTE: The fan weight is 35 pounds.
Step 6. Connect the fan wires to the outlet box
wiring by placing the bare ends of the wires to-
gether and then securing with a wire nut.
Connect in this order:
• GREEN leads from mounting plate and fan
to GROUND conductor of power source.
Secure with wire nut.
• WHITE wire from fan to white NEUTRAL wire
in ceiling fixture outlet box.
Secure with wire nut.
• BLACK wire from fan to black POWER wire
in ceiling fixture outlet box.
Secure with wire nut.
Inspect each wire nut and ensure that no bare
wire is visible; pull on each wire to test the con-
nection is mechanically sound.
Step 7. Tuck the wires into the canopy
with the wire nuts pointed upwards, so
that the WHITE and BLACK wires are on
opposite sides of the canopy and all wires
are clear of the canopy opening.
Step 8. Install canopy hatch with the last
canopy screw and lock washer. To do this,
tilt the fan body away from the hatch
opening.
Tighten the screws firmly by hand only,
Step 9. Straighten the fan, then check
to ensure that there is no movement be-
tween the canopy and ceiling or Hang-Tru
ball and top support shaft.
6
™

HANGING THE FAN

CANOPY ELECTRICAL CONNECTIONS

CANOPY HATCH INSTALLATION

WASHER
Note: Write down the
Serial Number and the
model number for future
reference.
BALL
SLOT
2 BLACK WIRES
2 WHITE WIRES
3 GREEN WIRES
WIRE NUT
CANOPY
HATCH
LOCK
CANOPY
SCREW
CANOPY
PIN
TILT THE
FAN TO
INSTALL
LAST
CANOPY
SCREW