Download Print this page

Advertisement

Quick Links

INTRODUCTION
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
mOUNTINg RECOmmENDATIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
fAN INSTALLATION
CONTROL fEATURES:
REmOTE OpERATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
TROUbLESHOOTINg . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
Safety and the proper operation of your Casablanca fan both require a thorough knowledge of the product
and proper installation; therefore, before attempting to install and operate your Casablanca fan, read this
owner's manual completely and carefully. Retain this manual for future reference.
CAUTIon: To avoid possible electrical shock, make certain that electricity is turned
off at the circuit breaker or fuse box before attempting any installation procedure.
• This fan is designed to be installed on an existing electrical outlet box. The outlet box must be UL Listed for
ceiling fan installations, if it is not, a new box must be installed. Casablanca extension poles are available for
sloped or high ceiling installations.
• This ceiling fan requires a grounded electrical supply of 120 VAC, 60 Hz and a minimum 15 amp circuit. The
maximum current requirement for the fan with light fixture is 3.8 amps. The fan uses about 1 amp or 100 watts.
Maximum light current is 1 amp or 100 watts of lighting.
• Where wire nuts are employed, be sure all bare wires are within the connectors. When installing the canopy
hatch, make sure all wires are within the canopy and that no wires are being pinched.
For best performance and for your warranty to be valid,
use only genuine Casablanca blades, light fixtures, and accessories.
• The blades in each pack are matched for equal
weight to assure smooth fan operation. If
more than one fan is being installed, be careful
not to mix blades from different cartons.
• Inspect the contents of your carton for possible
shipping or handling damage and report any
such damage directly to your authorized
Casablanca dealer.
• It is always a good idea to have an assistant to
help with the installation.
• When cleaning, painting, or working near
your fan, be very careful of the fan and blades.
Always turn the power OFF to the ceiling fan
before servicing it, working on it, or replacing
light bulbs.
• Never insert anything into the path of the fan
blades while the fan is in operation.
• Never install a fan over a pool or spa.
• Never operate a fan that has been damaged in
any way. Contact Casablanca Fan Company
by calling toll free 1-888-227-2178, or contact
your local authorized Casablanca dealer for
assistance in obtaining service.
CONTENTS
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
READ AND SAVE THESE INSTRUCTIONS

SAFETY FIRST

BEFORE YOU START
SAFE USE
(REmovE fUSE foR ThE
CIRCUIT yoU wIll BE
CIRCUIT BREAKER
(TRIp BREAKER foR ThE
CIRCUIT yoU wIll BE
PN C1043001 AT1208
fUSE BoX
woRKIng on)
woRKIng on)
18"
64"
84"
1

Advertisement

loading

Summary of Contents for Casablanca Modena II

  • Page 1: Safety First

    • Never install a fan over a pool or spa. • Never operate a fan that has been damaged in any way. Contact Casablanca Fan Company by calling toll free 1-888-227-2178, or contact your local authorized Casablanca dealer for assistance in obtaining service.
  • Page 2 MOUNTING RECOMMENDATIONS Before mounting your Casablanca fan, read the following helpful recommendations. The location of the fan, air circulation, and fan size are all important factors to consider before installation. Location Ceiling fans have practical uses in almost every room in your home. We suggest you follow these mounting recommendations as you decide where to install your Casablanca fan.
  • Page 3 ® odena INSTALLATION INSTRUCTIONS IMPORTANT! Leave the fan in the carton until you are ready to hang the fan. CEILING HARDWARE 1″ x 8-32 ROUND HEAD SCREWS (2) WIRE NUT (4) fLAT WASHER (2) LAg SCREW AND WASHER CROSSbAR mOUNTINg bRACKET GETTING STARTED Installing a New Ceiling Fixture Outlet Box After turning the power OFF at its source (either circuit If you do not have an existing fixture located where you breaker or fuse box), lower the old fixture and disconnect wish to place your Casablanca fan, an approved ceiling...
  • Page 4 CANOPY HARDWARE CANOpy HATCH CANOpy SCREW (4) CANOpy LOCK pHILLIpS WASHER (4) SCREWDRIVER CANOpy CANOPY INSTALLATION Step 3. Attach the canopy to the crossbar mounting ″ long canopy bracket with three of the 8-32 x 2 screws and canopy lock washers. Tighten the screw firmly by hand only.
  • Page 5 ® odena FAN PREPARATION Prepare for fan installation as follows: gROUND Step 4. Route the wires from the motor through the WIRE mOTOR WIRES Perma•Lock™ downrod and ball assembly. Tip: The downrod has a tapered thread that is designed to lock com- DOWNROD pletely when correctly installed. & bALL ASSEmbLy Step 5. Using the provided allen wrench, loosen the set TApERED...
  • Page 6 HANGING THE FAN Step 8. To hang the fan body in the canopy, hold the fan body firmly and insert the ball into the canopy opening. Check that no wires were bALL pinched. Rotate the fan body until the slot in the nylon ball fits into the pin opposite the canopy opening. NOTE: The fan weight is 28 pounds.
  • Page 7 ® odena INSTALLATION HALOGEN BULB AND GLASS Step 13. Screw the 100 Watt Halogen bulb into the socket. If it is touched, or dirty, clean carefully with a tissue. A dirty glass bulb will cause the bulb to fail almost immediately. CAUTION! Do not touch the bulb with your fingers–it is extremely important that the glass be clean.
  • Page 8 VERSA•TOUCH2® COnTROl InSTAllATIOn Versa•Touch2™ hardware (not to scale) Wood Screw Screw Drywall Screw 6-32 X " 6-32 X 1" 12v Battery Anchor 1" (2) 6-32 (2) W-72 W-72 Control Holder Control COnTROl BRACkET InSTAllATIOn SAFETY FIRST: To reduce the risk of electrical shock, this fan must be installed with an isolating wall control/ switch.
  • Page 9 ® REmOTE OpERATIOn Fan Control To start the fan. Press the selected speed button to run the fan at the desired speed. Send Signal LIgHT LOW=Low speed MED=Medium speed HIGH=High speed To turn off the fan, press the FAN OFF button. airflow direction To reverse the airflow, press the reVerse button.
  • Page 10 TROUBlESHOOTIng TIpS Please refer to this troubleshooting guide before requesting service or contacting your dealer for assistance. pROBlEm pOSSIBlE REmEDIES Fan will not start • Check the main circuit fuses, circuit breakers, and wall switch position. Check all wire connections. Make sure the power is turned off during this inspection. •...
  • Page 11 Note: any changes or modifications to the transmitter or receiver not expressly approved by Casablanca Fan Company may void one’s authority to operate this remote control.