Hanging The Fan; Canopy Electrical Connections; Canopy Hatch Installation - Casablanca General Owner's Manual

Step 3. To hang the fan body in the
canopy, hold the fan body firmly and in-
sert the ball into the canopy opening.
Check that no wires were pinched. Ro-
tate the fan body until the slot in the
nylon ball fits into the pin opposite the
canopy opening.
NOTE: Independent control of the
light fixture using a W-8 requires an
additional power wire run from the
wall switch to the fan. See Page 10
for wiring.
Step 4a. Attach the fan wires to the ceiling fixture outlet
box wiring by twisting the bare ends of the wires together
and then securing with a wire nut. Test that the connection
is secure by pulling on the wire nut. Connect in this order:
Step 4b. Pull Chain or W-4 Wiring Connections
• GREEN leads from mounting plate and fan to GROUND con-
ductor of power source. Secure with wire nut.
• WHITE wire from fan to white NEUTRAL wire in ceiling
fixture outlet box. Secure with wire nut.
• BLUE wire and BLACK power wire from fan to BLACK power
wire in ceiling outlet box. Secure with wire nut.
Step 4c. W-8 Wiring Connections
• GREEN leads from mounting plate and fan to GROUND con-
ductor of power source. Secure with wire nut.
• WHITE wire from fan to white NEUTRAL wire in ceiling
fixture outlet box. Secure with wire nut.
• BLACK power wire from fan to RED wire from W-8 in ceil-
ing outlet box. Secure with wire nut.
• BLUE wire from fan to YELLOW wire from W-8 in ceiling
outlet box. Secure with wire nut.
NOTE: See Page 10 for additional wiring information.
Step 5. Tuck the wires into the canopy
with the wire nuts pointed upwards, so
that the WHITE and BLACK wires are on
opposite sides of the canopy and all wires
are clear of the canopy opening.
Step 6. Install canopy hatch with the last
canopy screw and lock washer. To do this,
tilt the fan body away from the hatch
opening.
Tighten the screws firmly by hand only,
Step 7. Straighten the fan, then check
to ensure that there is no movement be-
tween the canopy and ceiling or Hang-Tru
ball and top support shaft.

HANGING THE FAN

CAPPED
BLUE
D1-OPTION
WIRE ON
3-SPEED ONLY
FOR INDEPENDENT
W-8 LIGHT
CONTROL

CANOPY ELECTRICAL CONNECTIONS

CANOPY HATCH INSTALLATION

LOCK
WASHER
BALL
SLOT
WIRE NUT
2 BLACK & BLUE
D1-OPTION WIRES
(WITHOUT W-8)
2 WHITE WIRES
3 GREEN WIRES
BLUE & YELLOW
WIRES
BLACK & RED
WIRES
2 WHITE WIRES
3 GREEN WIRES
CANOPY
HATCH
CANOPY
SCREW
PIN
PULL CHAIN OR
W-4 CONNECTIONS
W-8 CONNECTIONS
TILT THE
FAN TO
INSTALL
LAST
CANOPY
SCREW
7