Crossbar Mounting Bracket Installation; Canopy Hardware - Casablanca General Owner's Manual

CROSSBAR MOUNTING BRACKET INSTALLATION

NOTE: FOR INSTALLATION OUTSIDE USA (EXCEPT MODELS
ENDING IN 'E') USE THE HANGING INSTRUCTIONS ON
PAGE 8.
Proceed with installation as follows:
Step 1. Route the wires from the ceiling outlet box through
the crossbar mounting bracket center hole. Attach the bracket,
with ground wire and ridges down, to the ceiling fixture out-
let box with the mounting hardware included with the outlet
box.
Tighten the screws firmly by hand only, being careful not to
bend the bracket by over tightening.
CAUTION: To reduce the risk of
personal injury, use only the
mounting hardware provided with
the approved outlet box to install
the crossbar mounting bracket.
CANOPY
HATCH
Step 2. Attach the canopy to the crossbar mount-
ing bracket with three of the 8-32 x 2
canopy screws and canopy lock washers.
Tighten the screw firmly by hand only.
NOTE: On sloped ceilings, align the
canopy opening towards the top or
room peak.
6
CEILING FAN
APPROVED
WIRING BOX
CEILING
WIRING
CROSSBAR
MOUNTING
BRACKET

CANOPY HARDWARE

CANOPY
CANOPY INSTALLATION
1 † long
/
4
FLAT
WASHER
APPROVED
OUTLET BOX
HARDWARE
CANOPY LOCK WASHER (4)
CANOPY
CANOPY LOCK
WASHER
CANOPY
SCREW
RIDGE
SIDE
DOWN
GREEN
GROUND
WIRE
CANOPY SCREW (4)
CROSSBAR
MOUNTING
BRACKET