Fan Installation; Getting Started; Crossbar Mounting Bracket Installation - Casablanca Trident Owner's Manual

Hide thumbs Also See for Trident:

Manual (19 pages)

Table of Contents

installing a new Ceiling Fixture outlet Box

if you do not have an existing fixture located where you wish

to place your Casablanca fan, an approved ceiling fixture

outlet box must be installed and wired.

WARnInG!

to reduce the risk of fire, electrical shock, or

personal injury, mount to outlet box marked

"acceptable Fan Support of 22.7 kg (50 lbs.) or

less" using the mounting hardware provided with

the outlet box.

cRoSSBaR MounTInG BRackeT InSTallaTIon

ceIlInG haRdwaRe (not to scale)

crossbar Mounting Bracket

note: after removing the old fixture, check the outlet box

to insure that it is supported by a joist or beam across its

upper surface. if not, a 2 x4 stud must be installed.

Step 1a. Remove the knockout plug in the center of the

outlet box or drill a

-inch hole for the lag screw to pass

through. Then drill a

-inch guide hole into the joist or

beam to a depth of 3 inches.

Step 1b. Route the outlet box wires through the center

hole of the crossbar mounting bracket as shown. attach

the crossbar mounting bracket to the outlet box with the

screws provided in Pack a, making sure the outlet box

wires are not pinched by the washer.

Caution:

to reduce the risk of personal injury, use only the

mounting hardware provided with the approved

outlet box to install the crossbar mounting

bracket.

WARnInG!

Support directly to building structure only.