MIXVIBES CROSS DJ User Manual page 24

disabled. the same is true for the Right Input dropdown and the a/B buttons on
the right side of the waveform.
If the buttons are enabled, you can use them to assign the left Input and/or the
right Input to either player a or player B by clicking the corresponding buttons.
the following image shows an example, where only the left Input channels of the
audio interface were routed. also the left Input was assigned to player a.
Left Input is configured
Buttons are enabled
Left Input assigned to Player A
Setting the Player Source to Line In
the last step that needs to be done is to set the Input mode of the croSS DJ player
to line In, if you wish the external audio source to be heard through the player/
mixer. the input mode button can be found on the mixer panel above the equalizer/
gain knobs.
Player A is set to
Input Mode Line In
you can set the input mode to player or to line In.
•
Player When the input mode is set to Player the audio from the media file is
sent to the croSS mixer.
•
Line In When the input mode is set to line In, the external audio signal is sent
to the croSS DJ mixer. Which of the external inputs is sent to either player a
or B depends on the selection you made in the Head-up Display (see previous
section).
If you use either u-mIX control pro or u-mIX control 2 you can set the input
mode on the controller by holding the Shift button and pressing the Headphones/
Source button.
Right Input is not configured
Buttons are disabled
Player B is set to
Input Mode Player
Connect and Configure your Hardware
24