U-Mix Control Pro In External Mixer Mode /19 - MIXVIBES CROSS DJ User Manual

11 open the list box Output 2. on Windows select U-Mix Control Pro 3/U-Mix
Control Pro 4 and on oS X select output 3/4, if these outputs are not already
selected. this output receives the cue/monitor signal.
the routing image in the lower part of the dialog shows the how the audio
is routed from the croSS mixer to your audio interface. the audio panel
should look as shown in the following figure:
4.2 U-MIX CONTROL PRO in External Mixer Mode
If you have an external mixer you can use this mixer to mix the audio coming from
the two croSS players. the mixer section of the u-mIX control pro controller
is disabled in this setup. However, all other controls of the controller are available
to add fX or to use locators, for example. the following steps explain how to con-
nect the components and how to configure the audio routing in CROSS.
1 use an rca cable and connect outputs 1/2 of your u-mIX control pro to
line input 1 of your mixer.
2 use another rca cable and connect outputs 3/4 of your u-mIX control
pro to a line input 2 of your mixer.
3 connect your headphones to the Headphones sockets on your mixer.
4
If you wish to use a microphone connect it to the microphone input on your
mixer.
Connect and Configure your Hardware
19