MIXVIBES CROSS DJ User Manual page 99

TURN: Select Loop Length
PRESS: Activate/deactivate Loop
croSS sets the loop start point at the current position of the playback
marker, if Snap is disabled, or snaps it to the currently selected snap
length, if Snap is enabled. then the loop is activated.
the button with the selected loop length is highlighted. the loop button in
the loop section is highlighted as well, showing you that a loop is active.
on the waveform the section of the track that is looped is highlighted with a
white triangle. In the full track display the looped part is shown in a bright
colour and the rest of the track in a dark colour.
3 While the loop is active you can:
•
change the loop length, by using the (J) and (K) keys, or by clicking one
of the other buttons in the loop control, or by turning the loop encoder
on your u-mIX control controller.
•
Deactivate the loop either by using the (L) key, or by clicking the Loop
button or by pressing the loop encoder on your u-mIX control.
Using Manual Loops
the length of manual loops can be set as needed. to create a manual loop you
need to define a loop in point as well as a loop out point.
1
move the waveform to the position of the desired loop in point, or wait until
playback reaches the position, where the loop in point shall be set.
2 click the In button or press the (I) key.
3 move the waveform to the position of the desired loop out point, or wait until
playback reaches the position, where the loop in point shall be set.
Advanced Features
99