Using Cue Points /100 - MIXVIBES CROSS DJ User Manual

4 click the Out button or press the (O) key.
the looped section of the track is marked in the waveform and in the full
track display. additionally the loop is activated: the loop button is now
highlighted.
once they are created manual loops behave in the same way as automatic loops.
to change the loop size of a manual loop you can either set a new loop out point or
move the current one. this is explained in the next section.
Moving the Loop
Sometimes you will find that the loop is not exactly where you want it. The Smart
Seek feature of croSS DJ makes it easy to move an activated loop:
1 First you need to define the Jump length by performing one of the following
actions:
•
click the Smart Seek length display until the desired jump length is
shown.
•
Hold the SHIft button on your u-mIX control controller and press the
loop encoder until the desired jump length is shown in the Smart Seek
length display.
2 now you can move the loop by performing one of the following actions:
•
click the Smart Seek Backward or the Smart Seek forward button.
•
press (Alt)+(æ) to move the loop towards the begin of the track or
press (Alt)+(Æ) to move it towards the end of the track
•
Hold the SHIft button on your u-mIX control controller and turn the
loop encoder.
TIP use the loop feature together with the locators that are explained in the
next section: set a locator at a point that you want to use as the loop in point,
jump to that locator and finally use one of the auto loop buttons to activate
the loop.
9.3 Using Cue Points
If you load a track for the first time, CROSS DJ will create a cue point at the begin-
ning of the track. the cue point is symbolised on the waveform and in the full track
display by a cue marker, which looks a little bit like a flag on a flagstaff.
Advanced Features
100