MIXVIBES CROSS DJ User Manual page 39

7 for controls like amount that set a value, not only faders and knobs but
buttons can be used if you wish to set the value stepwise. make sure that
the mIDI control mapping dialog for the amount control is still open and
press a button on your controller. the available Preset Options change as
shown in the following figure:
use the preset Direct Normal Button if you wish to set the control to a par-
ticular value. Use the Value field in section Preset Option to define the value
in the range from 1 to 100.
use the preset Normal Inc. Button or Normal Dec. Button if you wish to
change the value stepwise. using Normal Inc. Button increases the value
and Normal Dec. Button decreases it. then enter the step size into the
field Value. the step size can be in the range from 0.00 to 1.00. addition-
ally you can activate the auto-repeat option, if you want the value to be
decreased/increased not just once, but for as long as the mapped button is
held.
the two presets Normal Inc. Trigger and Normal Dec. Trigger lead to the
same result as using the corresponding button presets. However, for a
control mapped to a trigger function no auto-repeat options are not avail-
able.
8 now open the category Application and click the Add Mapping button next
to Activate Next Player. activate next player can be used to set the input
focus to one of the players. all commands that are mapped in the category
Current Player are sent to the player that is currently active.
9 press a button on your controller and take a look at the available presets.
Connect and Configure your Hardware
39