Snapping Loops, Locators And Cue Points /98; Looping /98 - MIXVIBES CROSS DJ User Manual

9.2 Snapping Loops, Locators and Cue Points
With the beatgrid feature loops, locators, and cue points can be set either at the
current playback position or they can automatically snap to the next beat, next 1/2
beat, next 1/4 beat or next 1/8 beat of the tracks' beatgrid.
to enable the snap feature for one of the players, click the Snap button on the
player. you can set the snap value by clicking the Snap Length indicator next to
the Snap button.
croSS DJ stores the status of the Snap button when you exit croSS DJ and res-
tores it on the next launch.
9.3 Looping
CROSS DJ allows you to set loops in your tracks on the fly. You can either use the
automatic loop feature with one of the predefined standard loop sizes or you create
manual loops by setting the loop In point and the loop out point.
Automatic Loops
Using Automatic Loops
each croSS player contains a loop section below the waveform. you can use the
loop section to set the length of automatic loops and to activate the loop at the
same time. croSS provides several default loop sizes, ranging from 1/8 beat up
to 16 beats.
follow these steps to create an automatic loop:
1 make sure that the loop section is visible below the player. If you cannot see
the loop section drag the separator line below the players to make space
for the loop section.
2 perform one of the following actions:
•
click the button with the desired loop length.
•
press (ÿ) to activate the player with the track you wish to set the loop.
press (J) and (K) until the button with the desired loop length is high-
lighted with a frame. press (U) to activate the auto loop.
•
turn the loop encoder on the u-mIX control controller to select the
desired loop length. press the loop encoder to activate the loop.
Manual Loops
Loop Activation
Advanced Features
98