Operating Parameters; Using The Find Command To Find Non-Zero Meters; Table 25 - Nortel Meridian 1 Manual

Operating parameters

Table 25

Using the Find command to find non-zero meters

Input
Response
FInd MEter
ADMN METER
FInd MEter
ROOM METER
FInd MEter ALl <CR>
ROOM METER
FInd <CR>
ROOM METER
FInd <CR>
NO DATA FOUND
If only one meter is requested, and its value is zero, the first higher numbered
DN with a non-zero meter will be printed.
When searching a group of meters, the second DN entered must be higher
than the first.
If there are no non-zero meters in the group, the terminal prints NO DATA
FOUND.
A command containing FInd all by itself is valid only immediately following
another FInd command that resulted in a non-zero meter (any result other than
NO DATA FOUND).
3004 <CR>
3004 DISP
9001 9025 <CR>
9015
1003 DISP
4035
Message Registration
Comments
Meter for one DN
8 DN 3004 has a non-zero meter.
Meters for a group of consecutive DNs
23 DN 9015 is the first DN in the group with a
non-zero meter.
Meters for all DNs
13 DN 1003 is the first DN with a non-zero meter.
6 DN 4035 is the next DN with a non-zero meter.
There are no more non-zero meters.
Background Terminal Facility
Page 85 of 120
Description