Operating Parameters - Nortel Meridian 1 Manual

Operating parameters

Table 29
Using the Find command for Room Status (Part 1 of 2)
FInd STatus 1143 <CR>
STATUS 1143
One DN
FInd STatus 2401 2403 <CR>
STATUS 2401
A range
of DNs.
FInd <CR>
STATUS 2402
FInd <CR>
STATUS 2403
FInd STatus 3200 3205 VAcant <CR>
STATUS 3200
If you enter a FInd command with only one DN in it and you do not name any
status condition, that DN's status will be printed.
If you enter only one DN and you name a status, the FInd command will begin
looking for a DN with that status, starting at the DN entered and ending with
the largest DN in the system. It will print the first one it finds.
For a group of DNs, the second DN entered must be a higher number than the
first.
If there is no DN in the range you specify with the status you name, the
message NO DATA FOUND is printed.
The word FInd all by itself is valid only immediately after a FInd command
which produced non-zero results (any result other than NO DATA FOUND).
OCC REQD
OCC REQD
VAC PASS
VAC CLND
VAC REQD
UNR
UNR MWL
COS MWL
COS MWL SALE
COS
Background Terminal Facility
Room Status Page 105 of 120
CAT: 5 LANG: 0
CAT: LANG: 0
CAT: LANG: 0
CAT: LANG: 0
CAT: LANG: 0
Description