Operating Parameters - Nortel Meridian 1 Manual

Message Registration Page 75 of 120

Operating parameters

When setting the meters for a group of consecutive DNs, the second DN
entered must be a higher number than the first and can be in the range
0–32766.
You can use X substitution (see "Define options for the Set command" on
page 17). For example, SEt MEter 32X VAlue 1 will set all the meters
320–329 to the value 1.
The response shown in the examples appears only if the COnfirm option is on
(see "Define options for the Set command" on page 17).
You may not be able to SEt all DNs at once if the ALl option is not on (see
"Define options for the Set command" on page 17).
You may not be able to SEt a group of consecutive DNs if the RAnge option
is not on (see "Define options for the Set command" on page 17).
Using DN and VAlue only to enter a list of meter changes, as in Step 3, is
valid only immediately following a SEt MEter command.
The word VAlue is required for one DN, but is optional in other cases.
Background Terminal Facility Description