You Tried To Create A Multi-Page Pdf, But Were Not Able To Scan Multiple Documents; When You Click A Button On The Mp Toolbox, An Unwanted Application Opens; You Opened The Properties Dialog Box; Activated (Windows 2000) - Canon MultiPASS MP360 User Manual

You Tried To Create A Multi-page PDF, But Were Not
Able To Scan Multiple Documents
Cause
The ScanGear MP (Advanced
Mode) setting in the [Preferences]
dialog box is incorrect. (Because
[Automatically quit ScanGear MP
after scanning] is selected in
[Preferences] of Advanced Mode,
multiple documents cannot be
scanned.)
When You Click A Button On The MP Toolbox, An
Unwanted Application Opens
Cause
In the MP Toolbox, the application
you want to open is not registered.
You Opened The Properties Dialog Box From The
[Scanners and Cameras] Icon And Changed The
Settings, But The Settings Were Not Activated
(Windows 2000)
Cause
The settings are not activated
because you have not restarted
your computer.
Chapter 11
If you want to scan additional documents, follow the steps below to
deselect [Automatically quit ScanGear MP after scanning] before
scanning.
1. Click a button other than [Settings] on the MP Toolbox.
The respective setting dialog box is displayed.
2. Select [Use the scanner driver to make advanced settings]. Then
click [Start] to open ScanGear MP.
3. Click the [Settings] tab, then click [Preferences].
The [Preferences] dialog box is displayed.
4. Remove the check mark from [Automatically quit ScanGear MP
after scanning], then click [OK]. Scan documents.
Click a button on the MP Toolbox, click [Set] on the screen
displayed, and select the application you want to open for that button.
(See Software Guide, located on your Setup CD-ROM)
Once you have changed your settings, restart your computer.
Action
Action
Action
Troubleshooting
103