Aligning the printhead
To align the printhead after you have just installed it, follow the procedure in the Setup Sheet.
If you have printed the nozzle check pattern (
needs aligning, align it from the operation panel (see below) or from the MultiPASS Suite
software (
Software Guide).
Follow this procedure to align the printhead from the operation panel:
1
Press [Menu].
2
Use [2] or [3] to select <MAINTENANCE>.
3
Press [Set].
M A I N T E N A N C E
1 . N O Z Z L E C H E C K
4
Use [2] or [3] to select <ALIGN PRINT HEAD>.
5
Press [Set].
• The machine prints a horizontal line pattern.
C H A N G E H V A L U E
6
In column A on the printout, note which box has the most solid image.
Note the value next to this box and use [2] or [3] to enter it.
7
Press [Set].
8
Repeat steps 6 and 7 for columns B to F.
When all values have been entered, the LCD displays the following:
P R I N T V E R T . P A T T E R N ?
YES=(A)
9
Press
[T].
11-8
Maintenance
A
0
BAD SAMPLE
Least solid
box
GOOD SAMPLE
Most solid
box
NO= (#)
p. 11-7) and determined that the printhead
Chapter 11