Page 1
MultiPASS F50 Setup Instructions Step 1: Unpack the F50 MFP 1. Carefully remove all items from the box. Step 2: Set up the F50 MFP 1. Remove shipping tape and protective shipping materials.
Page 2
2. Open the scanning unit by pressing the Open button. Remove the shipping material. 3. Unlock the scanner. Set the scanning lock to unlock. Press the scanning unit closed until it clicks. 4. Attach the trays:. Step 3: Prepare the F50 MFP 1.
Page 3
3. If the F50 MFP does not power up when plugged in, press the ON/OFF button to turn it on. NOTE: to enter sender information, including date and time, see page 13 of your MultiPASS F50 User's Manual. 4. Open the scanning unit again. The printhead holder will move to the center position.
Step 4: Install the Printhead 1. Remove the printhead from its package. 2. Turn the printhead over, then remove the orange protective cap. NOTE: Do not touch the electrical contacts. 3. Raise the gray lock lever. 4. Gently slide the printhead into the holder. The printhead will rest at a slight angle. Do not press it down.
Step 5: Install the Ink Tanks 1. Pull the orange tab off the yellow ink tank (BCI-3eY), then remove and discard the plastic wrapper. 2. Twist off and discard the orange protective cap. NOTE: To avoid spilling ink, never press on the sides of the ink tank. 3.
Step 6: Align the Printhead 1. Place a stack of paper in the multi-purpose tray in preparation for printhead alignment. 2. Once the printhead has been installed ALIGN PRINTHEAD/PRESS SET KEY will display on the LCD panel. Press the key once. 3.
Page 7
NOTE: if you have difficulty on Columns B or C when choosing between two patterns, use the larger value number. If you have difficulty when choosing between patterns for Columns D, E or F, use the smaller value number. 6. When values for all vertical columns on the printout have been entered, the LCD will display LAT LINE PATTERN, and a lateral (horizontal) pattern will print.
Page 8
6. Read the License Agreement. If you agree to its terms, click YES. If you do not agree, click NO. You will not be allowed to continue the installation process. 7. Select the MultiPASS F50 for installation. Continue to follow the on-screen instructions.
Page 9
9. Continue to follow on-screen instructions to complete the installation process. 10. When installation is complete, you will need to restart your PC before using the MultiPASS Suite software. If your PC does not restart automatically, restart it manually. NOTE: Remember to register your product to ensure product support. The serial number is located on the back of the F50 MFP, above the parallel port.
Page 10
7. Read the License Agreement. If you agree to its terms, click YES. If you do not agree, click NO. You will not be allowed to continue the installation process. 8. Select the MultiPASS F50 for installation. Continue to follow the on-screen instructions.
Need help?
Do you have a question about the MultiPASS F50 and is the answer not in the manual?
Questions and answers