If The Nozzle Check Pattern Does Not Print Properly; Interpreting The Messages - Canon MultiPASS F60 Comprehensive Manual

5
Pull out the jammed page from
the ADF.
6
Lower the paper release lever A
and then close the feeder cover.
• If [Stop/Reset] is pressed during scanning
and the document remains in the ADF, wait
for the machine to return to standby mode,
then press [Resume]. Documents left in the
ADF will be ejected automatically.
If the nozzle check pattern does not print
properly
Refer to Maintaining the printhead, p. 11-6.

Interpreting the messages

When the Alarm light blinks
Check the message in the LCD. If there is a message, follow the instructions and correct the error.
Then to resume operation, press [Resume]. The Alarm light will turn off.
If the error remains, turn off the machine and disconnect the power cord. Wait 15 seconds, then
reconnect the power cord and turn on the power.
If you cannot clear a paper jam
Turn off the machine and disconnect the power cord. Wait five seconds, reconnect the power cord
and turn on the power. If the problem has been resolved, the Alarm light will turn off.
If the Alarm light still lights even after you have turned the power on again
Contact the Canon Customer Care Center.
Error codes are printed in the ACTIVITY REPORT.
Chapter 12
A
Troubleshooting
12-17