Table of Contents
Advertisement
2 New Features
2.1 Festo CPX-CP Interface
Introduction
Documentation
published by Festo AG &
Co. KG
Required Hardware and
Operating System
Versions
Contents
8
The CPX-CP interface is an expansion module for the CPX terminal of the
Festo AG & Co. KG. The CPX-CP interface serves to connect the fitting CPI
modules by Festo (CP valve terminals and CPI-I/O modules).
192 digital inputs and 192 digital outputs can be directly connected to a
CPX-FB14
Further, up to 4 analog inputs and outputs can be connected
The individual modules of the CPX and CPI system have been specifically
described in the documentation published by Festo AG & Co. KG. Giving heed
to the safety regulations listed there, as well as only using the modules for
their intended purpose are imperative.
The following hardware and operating system versions are required for
applying the CPX-CPI interfaces to Jetter AG controllers:
Module
JC-24x
JX6-SB / JX6-SB-I
CPX-CP-4-FB
CPX-FB14
This chapter contains the following topics:
Topic
Restrictions at Using the CAN System Bus .................................................... 9
Access to the Modules at the CPX-CP Interface .......................................... 10
Comment
Controller
JX6 submodule
Festo: CPX-CP interface
Festo: CANopen field bus node
As of Software
Release
V 3.26
V 2.21
Page
Jetter AG
Advertisement
Table of Contents
