Table of Contents
Advertisement
F/T RING TIME
When your unit is set to receive both fax and telephone calls
automatically, it rings to alert you to pick up the handset if the call is
from a person. If you do not pick up the handset within a certain
amount of time, the unit stops ringing. Use this option to change the
number of times the unit rings, from 10 to 60 seconds. The default is
22 seconds.
DEFAULT ACTION
Not all fax machines are capable of sending a fax tone (the CNG tone
that warns the receiving fax machine that a fax is coming). For those
cases the unit may think that the call coming in is a voice call and
rings to alert you of the call (the amount of time it is going to ring is
determined by the F/T RING TIME setting above). If you do not
answer the call, one of two things can happen:
1. If you set the DEFAULT ACTION to RECEIVE, the unit will
2. If you set the DEFAULT ACTION to DISCONNECT, the unit will
7-6
Receiving Faxes
switch to fax receive mode automatically at that point and start
to receive the document. If no document comes in, it disconnects
the call after approximately 40 seconds. The factory default
setting is RECEIVE.
disconnect the phone call immediately freeing up your phone
line at this point.
Chapter 7
Advertisement
Table of Contents
