Table of Contents
Advertisement
Power-On-Self Test
Power-On-Self Test
Power Architecture
1-10
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Arrow.com.
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
The Power-On-Self-Test Program (POST) tests all EZ-KIT Mini periph-
erals and validates functionality as well as connectivity to the processor.
Once assembled, each EZ-KIT Mini is fully tested for an extended period
of time with POST. All EZ-KIT Mini boards are shipped with POST pre-
loaded into flash memory. The POST is executed by resetting the board
and pressing the proper push button(s). The POST also can be used as a
reference for a custom software design or hardware troubleshooting.
Note that the source code for the POST program is included in the
ADSP-BF706 EZ-KIT Mini Board Support Package along with the
file that describes how the board is configured to run POST.
readme.html
The ADSP-BF706 EZ-KIT Mini has two methods to power the board—
through the debug agent's USB mini connector (
micro USB connector (
P8
By selecting the jumper positioning on
swapped between the two. Only change the
USB cables are removed.
• Method 1. To configure the board to use the 5V power from the
debug agent's USB mini connector, set
(labeled
).
DA
• Method 2. To configure the board to use power from the USB
micro connector, set
The debug agent can be powered separately, even with the
the
as the power source (jumper on positions
706
USB cable connected to a PC in both the micro and mini USB connector.
ADSP-BF706 EZ-KIT Mini Evaluation System Manual
ZP1
) attached to the ADSP-BF706 processor.
, the power source can be
JP2
jumper setting when both
JP2
JP2
to positions
and
JP2
2
) or through the
to positions
and
1
2
(labeled
).
3
706
setting of
JP2
and
), by inserting a
2
3
Advertisement
Table of Contents
Need help?
Do you have a question about the ADSP-BF706 EZ-KIT Mini and is the answer not in the manual?
Questions and answers