5�2 10T 3D Printed Rotation Pinion - WCP SS Swerve User Manual

WCP SS Swerve - User Guide
(Rev 1)
5.2 10T 3D Printed Rotation Pinion
Push the 3D printed rotation pinion onto the 2 stage rotation shaft� There is a 2mm
nd
keyway integrated into the shaft and the 10T 3D printed rotation pinion has a 2mm key
integrated into the gear itself� Make sure to align the key in the gear with the keyway on
the shaft and then push the pinion onto the shaft� Once installed push the 8mm push
nut onto shaft to secure the 10T 3D printed rotation pinion�
Note: This should require very little force and if a lot of force is required please check
the 3D printed part to ensure that it is clean� Also ensure that you have matched the
keyway with the key in the gear as mentioned above�
Disclaimer: If the 10T 3D printed rotatin pinion is damaged due to excessive force it
will not be replaced by WestCoast Products.
WCP SS Swerve - User Manual (Rev 1) Page 48