3�8 Install Wheel Forks - WCP SS Swerve User Manual

WCP SS Swerve - User Guide
(Rev 1)
3.8 Install Wheel Forks
Align roll pins with the small set of holes on the main rotation gear as shown� Then bolt
the forks in from the bottom with the #10-32 SHCS x 1�75" Length bolts�
Note: The roll pins are there to aid in assembly and alignment. If difficult to push roll
pins into holes you can drill out the 0�125" holes to the next size up and this will not
affect performance�
SHCS
WCP SS Swerve - User Manual (Rev 1) Page 18