3�21 Mounting The Drive Motor - WCP SS Swerve User Manual

WCP SS Swerve - User Guide
(Rev 1)
3.21 Mounting the Drive Motor
In order to install the 2 x #10-32 BHCS x 0�5" length bolts you will need to rotate the
main rotation gear such that the large 2 holes are aligned with the CIM mounting holes�
Then use an allen key to go through the holes on the main rotation gear to be able to
tighten the drive motor mounting bolts�
Note: If you need to replace your drive motor for any reason you will have to remove the
drive wheel to access these bolts in the future�
WCP SS Swerve - User Manual (Rev 1) Page 31