St Stage Shaft Assembly - WCP SS Swerve User Manual

WCP SS Swerve - User Guide
(Rev 1)
3.7 1 Stage Shaft Assembly
st
Insert the 1 Stage Shaft from the top of the rotation gear� Slide the thrust washer onto
st
the shaft so that it touches the face of the gear� Slide the 15T bevel gear onto the shaft
and then slide the 2mm machine key into the grove� Finally, install the 3/8" snap ring to
hold it all together�
Note: It may be easier to insert the 2mm machine key into the grove on the shaft then
slide the 15T bevel gear over the machine key and shaft�
WCP SS Swerve - User Manual (Rev 1) Page 17