4�3 Ctre Mag Encoder Mount - WCP SS Swerve User Manual

WCP SS Swerve - User Guide
(Rev 1)
4.3 CTRE Mag Encoder Mount
Install the 3D printed CTRE mag encoder mount by aligning the 2 x #10-32 BHCS bolts
x 0�5" length and tightening them until secure� Finally take the CTRE mag encoder and
place it so that the sensor side is face down and then thread the CTRE mag encoder
bolt into the mount�
Note: CTRE mag encoder/CTRE mag encoder bolt is not included in this kit and must
be bought separately�
Disclaimer: Do not over tighten the 2x #10-32 BHCS bolts x 0.5" length into the plate
as over tightening them can cause the 3D printed part to be deformed.
WCP SS Swerve - User Manual (Rev 1) Page 44