3�27 Installing The Dead Axle Pt� 2 - WCP SS Swerve User Manual

WCP SS Swerve - User Guide
(Rev 1)
3.27 Installing the Dead Axle Pt. 2
Push the shaft all the way through the wheel until it comes out of the other bearing as
shown below� Secure the shaft to the wheel by installing the 1/2" snap ring on to the
end of the shaft� The dead axle should not be able to separte from the wheel once this
snap ring is intalled�
WCP SS Swerve - User Manual (Rev 1) Page 37