Install The Dspdb Card - NEC XN120 Getting Started Manual

Install the DSPDB Card

Install the DSPDB Card
! Observe anti-static precautions when handling the DSPDB card.
·
Wear a suitable anti-static strap connected to an Earth point.
Refer to the DSPDB Guide 991422-5 for further information.
One DSPDB card is installed onto the base board within the XN120 main unit.
The DSPDB will be automatically assigned when the system is powered on, after the card is installed.
1 Power off the XN120 system
2 Remove the sub cover and
main cover of the XN120 unit
that will have the card
installed.
3 Fit the DSPDB card.
The card is installed onto the
connector CN6 on the base
board within the XN120 main
unit.
Fit the plastic mounting bars.
Install the DSPDB card.
Ensure the connector is in line
before pushing on the card.
4
You must also power off each XN120 expansion unit if you have any
installed.
Remove the sub cover
Loosen the 2
screws
Lift off
the
main
cover
Fit the four
plastic
mounting
bars.
DSPDB Multi Language Guide