aerauliqa QRCE Series Installation, Operation And Maintenance Manual page 5

• This manual together with separate wiring diagram and control instructions (supplied with the unit) must be kept in a dry
place and ready to hand for future consultation when required.
• This manual has been compiled to ensure that the unit is installed in the correct way and to supply comprehensive
information about how to correctly use and service the appliance. Before proceeding with the installation phase, please
carefully read all the information in this manual, which describes the procedures required to correctly install and
use the unit.
• Unit installation shall be done according to the laws in force in the country where unit will be placed.
• Manumission of electrical or mechanical parts of the unit will VOID THE WARRANTY.
• Check the electrical specifications on the identification plate before making the electrical connections. Read the
instructions in the specific section where the electrical connections are described.
• If the unit must be repaired for any reason, this must only be done by a specialized assistance center recognized by the
manufacturer and using genuine spare parts
• The manufacturer also declines all liability for any damage to persons or property deriving from failure of the information
in this manual to correspond to the actual machine in your possession.
• Proper use : forced air renewal with heat recovery in working environment as previously specified. Any use
differing from this proper use or beyond the operating limits indicated in this manual is forbidden unless
previously agreed with the manufacturer.
• The prevention of the risk of fire/injury at the installation site is the responsibility of the end user and/or installer.
Verify, upon acquisition, that the unit is complete and supplied as described.
Any eventual disputes must be presented in writing within 8 days from the reception of the goods.
Each unit is provided with identification plate listing the following:
•
Address of Manufacturer
•
"CE" Mark
•
Model
•
Serial Number
•
Date of production
•
Code
•
Max input current [A] (for basic unit)
•
Max input power [W] (for basic unit)
•
Power supply [V-ph-Hz]
•
Nominal (supply) airflow rate [m
•
External static pressure [Pa] (for basic unit)
•
Sound power level [dB(A)]
•
Operative range (as air temperature & RH)
•
Power supply [V-ph-Hz] for possible electric heater
•
Max input current [A] for electric heater
•
Max input power [W] for electric heater
MIUM0018_REV06_ QRCE_20180312-MIUM-ENG-AQ
3
/h]
ENG
AQ_001523_02_0721
5