aerauliqa QRCE Series Installation, Operation And Maintenance Manual page 14

4.4 Installation of roof cover (TPR-H, TPR-V, TPR-CH, TPR-CV)
•
In the event that roof covers are supplied apart to be mounted later than the unit and/or its external sections
CCS/CDX, it is always possible to install them on the existing unit/sections.
•
For external sections CCS/CDX, both horizontal and vertical version, it is supplied a roof cover which, before
coupling unit and section according to the instructions of next 4.5, shall be interchanged with the unit roof element
placed on the coupling side (fig. 9a).
•
For mounting roof cover elements, preventively unscrew the M6 screws by a 5 mm Allen key (A in fig. 9b); further,
on vertical unit, the upper bracket (B) shall be removed.
•
As first, place the intermediate roof cover plate, fix it by screwing the same M6 screws, preventively provided with
the special rubber washers supplied together with the roof covers.
•
The jointing side of each end side roof plates shall be first hooked to the intermediate plate vertical protrusions
by an about 45° rotation, then placed upon the upper panels and finally fixed by M6 screws with rubber washer.
•
Complete the installation by sealing the connection lines between element and element.
A
A
MIUM0018_REV06_ QRCE_20180312-MIUM-ENG-AQ
QRCE
QRCE
B
A
Fig. 9b
ENG
CCS/CDX
CCS/CDX Fig. 9a
A
AQ_001523_02_0721
14