Cal Flame Chef C100B Owner's Manual page 35

Lighting The Infrared or Rotisserie Burner
1. Open the hood.
2. Push and hold the rotisserie burner knob in for about 5
seconds to allow gas into the the infrared burner, then
rotate knob rapidly counter clockwise past the light
position (You will hear a loud click).
3. If the burner does not light on the first try, repeat
immediately.
4. If the burner does not light within 5 seconds, turn the
control knob to the OFF position. Wait 5 minutes until
the gas clears before attempting to light it again.
5. Repeat the procedure or try "Manual Lighting
procedure" as shown below.
6. Upon successful lighting, repeat the process on any
other available IR burner you may wish to light.
Manually Lighting The Infrared or Rotisserie Burner
1. Open the hood.
2. Push and hold the rotisserie burner knob in for about 5
seconds to allow gas into the the infrared burner, then
rotate knob rapidly counter clockwise past the light
position (You will hear a loud click).
3. Hold a lit long stem match next to the burner ports.
4. If the burner does not light within 5 seconds, turn the
control knob to the OFF position. Wait 5 minutes until
the gas clears before attempting to light it again.
5. If the burner does not light after several attempts see
troubleshooting located in the back of this manual.
6. Upon successful lighting, repeat the process on any
other available IR burner you may wish to light.
31
OFF
o
LIGHT
HIGH
LOW
Rev 06/01/2003