Table of Contents
Advertisement
INSTALLER GUIDE
6. Refit in reverse order.
16.7 To remove the L.E.D.
1. Remove the burner unit (See section 16.2).
2. Lay the burner on its back. Ensure that the work surface is suitably protected. This
will avoid damage to the work surface.
3. The L.E.D. is held in place by a rubber grommet. To remove the L.E.D. from the
grommet gently push the L.E.D. from the front.
4. Remove the L.E.D. plug from the back of the electronics box. Always hold the plug
body. Never pull on the wires.
5. Replace in reverse order.
16.8 To remove the battery holder.
1. Remove the burner unit (See section 16.2).
2. Lay the burner on its back. Ensure that the work surface is suitably protected. This
will avoid damage to the work surface.
3. Remove the batteries from the battery holder.
4. Remove the two screws from the centre of the battery holder.
5. The wires from the battery holder are connected to the electronics box by a push in
plug connector. Identify the connector. You will note that another wire leads from the
plug connector. This is an earth wire. Unscrew the end of the earth wire from the burner
unit body.
6. Remove the plug connector from the back of the electronics box. Always hold the
plug body. Never pull on the wires.
7. Replace in reverse order.
16.9 To remove the electronics box.
1. Remove the burner unit (See section 16.2).
2. Lay the burner on its back. Ensure that the work surface is suitably protected. This
will avoid damage to the work surface.
3. Carefully remove all
of the plug connectors
and electrode lead from
the back of the
electronics box.
4. Remove the two
screws securing the
electronics box to the
mounting bracket.
5. Replace in reverse
order. For the plug
connectors and electrode
Figure 41. Plug connector and electrode lead locations
Page 35
©
Baxi Heating U.K. Limited 2006.
Advertisement
Table of Contents
