Table of Contents
Advertisement
11. It is important that the grommet supplied in the
loose parts pack is fitted to the hole in the rear of the
convection box.
12.
For concealed
connection only: Pierce the
grommet to allow the pipe to
pass through it. The grommet
should envelop the pipe. If
the hole is larger than the
pipe, seal it with tape. Do
not pierce the grommet
unless the supply pipe is to
pass through it.
13. The appliance is supplied
with two fireback spacers.
Do not fit the fireback
spacers if the fire is to be
installed into a precast or
clay flue block system as in
section 4.2.3. These should
extend backwards to ensure sufficient clearance
from the back of the fireplace. Remove the label
and retaining screws from the rear sides of the
hotbox. Position the fireback spacer as shown in
figure 13. Secure the
fireback spacers using
the screws removed
previously and the two
supplied with the fire.
©
Baxi Heating U.K. Limited 2006.
INSTALLER GUIDE
Figure 11. Burner module
removal
Figure 13. Fireback
spacers
Page 19
Figure 10. Inner reflector
removal
Fireback 12. Fitting "U" Seals
Advertisement
Table of Contents
