Fitting Batteries To The Heat Engine; Setting The Handset And Receiver Relationship; Checking The Ignition Operation - Baxi 755 Installer's Manual

Remote control inset live fuel effect gas fire
Table of Contents

Advertisement

7.2 Fitting batteries to the heat engine.

The gas valve on the heat engine is battery powered. There are three 'C' size batteries
supplied. Fit the batteries into the battery holder on the front right hand side of the heat
engine. It is important that the + and - symbols on the battery match those of the
illustration inside the battery holder.

7.3 Setting the handset and receiver relationship.

The handset and receiver unit on the fire will not comunicate unless the following
procedure is completed. Ensure that sections 7.1 and 7.2 have been completed.
NOTE: Whenever the on-off button
on the handset screen for 5 seconds and return to 'OFF' if no other buttons are
pressed. This is a default in case of the on-off button being pressed accidentally.
xPress the on-off button
corner of the display screen).
xQuickly press and hold the on-off button
flame decrease
xPress the 'SET' button.
The L.E.D. light on the bottom left hand side of the fire will illuminate and the clock
symbol
will appear for approximately five seconds on the display screen. The remote
control handset is now set to operate the fire.

7.4 Checking the ignition operation.

xPress the on-off button
corner of the display screen).
xPress the 'SET' button. The L.E.D. light on the bottom left hand side of the fire will
illuminate and a small twin flame symbol will flash on the handset. There will be a
slight delay and several sparks should be seen between the electrode and pilot tip. If
there are no sparks check the following: -
xRepeat section 7.3 ensuring that the L.E.D. light on the bottom left hand side of the
fire illuminates when the 'SET' button is pressed.
xEnsure that the electrode lead is connected to the terminal at the base of the electrode.
xIf the above is correct, check for damage to the electrode lead.
©
Baxi Heating U.K. Limited 2006.
INSTALLER GUIDE
(The word 'ON' will now start to flash in the top left hand
buttons simultaneously.
(The word 'ON' will now start to flash in the top left hand
has been pressed the 'ON' word will flash
, the flame increase
Page 17
button and the

Advertisement

Table of Contents
loading

Table of Contents