Table of Contents
Advertisement
INSTALLER GUIDE
16.1 To remove the fascia.
1. The fascia is held in place by four retaining plates
at the back of the fascia. These slot into four retaining
brackets on the hotbox. To remove the fascia, hold the
sides of the fascia and lift upward and forward. The
fascia should lift clear of the hotbox (See figure 32)
2. Replace in the reverse order
16.2 To remove the complete burner unit.
1. Remove the fascia as in section 16.1.
2. Remove the ceramic fuel effect pieces.
3. Detach the spillage plate from the hotbox by
removing the four screws (See figure 33). Place the
Figure 32. Fascia removal
spillage plate in a safe place away from the
work area.
4. Remove the six screws from the side of the
inner reflector (See figure 34).
5. Carefully lift the inner reflector and pull
forward to remove.
Be careful not to scratch the top surface of
the burner cover. Place the inner reflector in a
safe place away from the work area.
6. Remove the two screws to the side of the
burner cover (See figure 35)
7. Detach the burner cover by lifting clear of
the burner module (See figure 35). Place the
Figure 33. Spillage plate removal
burner cover in a safe place away from the
work area.
8. Isolate the gas supply at the inlet
isolating 'T' connector
9. Support the inlet 'T' connector to avoid
straining the pipework and disconnect the
appliance from the inlet 'T' connector.
10. Detach the burner unit from the hotbox
by lifting clear
11. Replace in the reverse order.
Figure 34. Removal of inner reflector
Page 32
©
Baxi Heating U.K. Limited 2006.
Advertisement
Table of Contents
