Baxi 755 Installer's Manual page 22

Remote control inset live fuel effect gas fire
Table of Contents

Advertisement

INSTALLER GUIDE
centre line of the fireplace to ensure that the
appliance finishes centrally in the opening when
tension is applied to the cables.
3. Insert a fibre plug into each hole. Use the fibre
plugs supplied with this appliance - Never use
plastic plugs instead of the fibre plugs supplied.
Screw the eyebolts into the plugs. Make sure that
the bolts are secure.
4. Place the hotbox unit close to the fireplace but
allow sufficient access into the fireplace opening so
that the cables can be threaded through the eyebolts
Figure 18. Upper cable retention
and returned through the back of the hotbox. If a
concealed connection is being used, insert the hotbox
into the fireplace feeding the supply pipe through the
pierced hole in the rear grommet.
5. The hotbox has two holes at each side of the spillage
plate. Insert one end of each cable (one cable each side)
from the back through the lower of the two holes and
return the end through the upper of the holes (See
figure 18). Give the cables a pull so that they grip
against the hotbox flanges.
6. Thread the cables through the eyebolts. Return the
cables through the holes near the bottom of the hotbox
Figure 19. Cable route
back panel (See figure 19) (For precast or clay
block flue systems return the cables through the
slotted holes in the side of the hotbox).
7. Place the hotbox fully back into the fireplace
opening so that it is sealed against the fireplace front
surround.
8. Drill a hole into the fireplace floor through each of
the two holes in the base of the hotbox using a no.12
masonry drill (See figure 20).
9. Insert a fibre plug into each hole. Use the fibre
plugs supplied with this appliance - Never use plastic
plugs instead of the fibre plugs supplied. Fit a
Figure 20. Floor fixing
woodscrew in each plug and tighten.
Always screw the base into position before applying tension to the cables. This will
ensure a tight seal between the top of the hotbox and wall
10. Fit a cable retainer over the bottom end of each cable.
Page 22
©
Baxi Heating U.K. Limited 2006.

Advertisement

Table of Contents
loading

Table of Contents