Removing The Power Supply Transformer - KitchenAid KGRA806P Technical Education

REMOVING THE POWER SUPPLY TRANSFORMER

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug range or disconnect power.
2. Turn off gas supply to range.
3. Remove the control panel (see step 4 on
page 4-2 for the procedure).
4. Remove the control power supply (see
step 7 on page 4-7 for the procedure).
Power Supply Transformer
(Behind Control Power Supply)
5. Using a 90° offset screwdriver, remove
the screw from the power supply trans-
former.
6. Disconnect the 2-wire primary wire con-
nector on the power supply transformer
from the wiring harness. Cut the wire tie
from around the primary wires.
7. Unhook the flange on the end of the power
supply transformer from the mounting
bracket slot, and remove the transformer
from the front of the unit.
Flange In Slot
Screw
Power Supply Transformer
4-8
Primary Connector